Latest Forum Post
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲科廷大学Curtin毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,Curtin University
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲福林德斯大学Flinders毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,Flinders University
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理精英教育学院毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,Top Education Institute
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲维多利亚大学VUT毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,Victoria University
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲西悉尼大学WSU毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,Western Sydney University
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲阳光海岸大学USC毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,University of the Sunshine Coast
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲巴拉瑞特大学UB毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,University of Ballarat
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲西澳大学UWA毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,The University of Western
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲圣母大学ND毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,The University of Notre Dame
购买澳洲文凭,成绩单(Q微信95...
购买澳洲文凭,成绩单(Q微信956290760)办理澳洲纽卡斯尔大学UON毕业证成绩单学历认证,留信认证,电子版OFFER,成绩单,澳洲大学文凭,病假条,学期成绩单,The University of Newcastle
购买澳洲文凭,成绩单(Q微信95...
|
|
03 S-10 A COMPRESSOR WILL NOT COME ON
|
|
|
| |
|
LEJANSSEN
New User
Nov 18, 2009, 10:24 AM
Post #1 of 11
(1651 views)
|
03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
HAVE AN 03 S-10 WITH 4.3 V-6. RECENTLY PULLED DASH TO REPLACE HEATER CORE. AC WORKED FINE BEFORE. NOW COMPRESSOR WILL NOT KICK ON. CHECKED ALL FUSES IN FUSE PANEL ON SIDE OF DASH. TRYED TO CHECK RELAY UNDER HOOD, BUT COULD NOT GET AC RELAY TO COME OUT. PULLED DASH OUT AGAIN TO MAKE SURE EVERYTHING CONNECTED PROPERLY, AND CAN SEE NO ISSUES THERE. ANY ADVISE WOULD BE APPRECIATED
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 18, 2009, 11:15 AM
Post #2 of 11
(1642 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
Dumb question but did you recharge the system after putting the dash back in? ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
LEJANSSEN
New User
Nov 18, 2009, 11:59 AM
Post #3 of 11
(1632 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
NOT A DUMB QUESTIONS AT ALL. HAVE NOT RECHARGED SYSTEM CAUSE DID NOT DISCONNECT ANY OF THE AC SYSTEM WHEN REMOVING DASH. NOT SURE IF I CAN EVEN ADD TO SYSTEM WITHOUT COMPRESSOR BEING ON. DO NOT WANT TO OVERCHARGE
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 18, 2009, 12:16 PM
Post #4 of 11
(1627 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
Well, check all your wiring connections, all the switches, especially the one on the accumulator, and all the fuses. If all that checks out, then you'll have to check the pressure to make sure is still have refrigerant in it. If you still have problems. I've give you a wiring diagram to follow. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
LEJANSSEN
New User
Nov 18, 2009, 12:38 PM
Post #5 of 11
(1623 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
CAN I CHECK ON THE LOW PRESSURE SIDE WITHOUT THE COMPRESSOR ON AND IF SO WHAT WILL THESE READINGS TELL ME ?
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 18, 2009, 12:47 PM
Post #6 of 11
(1618 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
You need a minimum of 50 PSI "off" for the compressor to engage. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Nov 19, 2009, 12:03 AM
Post #7 of 11
(1612 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
To add: Pressure should be close to ambient temp if F Just sitting still. If not there's a leak to be found and fixed, - could have been just bad luck? T
|
|
| |
|
LEJANSSEN
New User
Nov 23, 2009, 7:16 PM
Post #8 of 11
(1593 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
WENT AHEAD AND FED A CAN OF R134A INTO THE SYSTEM. COMPRESSOR ACTUALLY KICKED ON FOR A FEW SECONDS, THEN KICKED BACK OFF, THEN KICKED BACK ON, AND OFF, AND ON. WELL YOU GET THE PICTURE. WHEN THE CAN WAS EMPTY, I CHECKED THE PRESSURE IN THE SYSTEM. WHEN THE COMPRESSOR WAS CYCLED ON, PRESSURE WAS ABOUT30 PSI, BUT WHEN IT CYCLED OFF, PRESSURE JUMPED TO ABOUT 70 PSI. 70 PSI IS IN THE RED ZONE ON MY GAUGE SO AM KINDA FREAKED OUT. ANY IDEA WHAT I SHOULD DO NEXT ? JUST MADE THE LAST PAYMENT, SO REALLY HATE TO GET RID OF MY TRUCK. THANKS
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 23, 2009, 7:29 PM
Post #9 of 11
(1588 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
It's short cycling because it's still low on refrigerant. Add another can, maybe 2. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Nov 23, 2009, 7:38 PM
Post #10 of 11
(1584 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
At this same section go to "charging produdures" high on the list. If not charged near exactly right it won't work right - worse it can cost you thousands if not done right! Way over can lock up and under will underlube compressor. It's not a crap shoot and try thing and you need gauges + a scale or get help! T
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Nov 23, 2009, 7:50 PM
Post #11 of 11
(1576 views)
|
Re: 03 S-10 A COMPRESSOR WILL NOT COME ON
|
Sign In
|
|
The total capacity for that truck is 28 ounces. the cans should be 12 ounce each so an empty system will hold 2.5 cans. I suspect yours started with less than 2 ounces so you can calculate how much to put in. No more than 2.5 cans. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|