Main IndexAuto Repair Home Search Posts SEARCH
POSTS 		Who's Online WHO'S
ONLINE 		Log in LOG
IN




Automotive Repair
Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:   
  Login
  Sign up here!



Latest Forum Post
with_replies.gif image   Car idles funny but doesn't throw codes
2006 Hyundai Elantra Engine size: 2.0L m...

with_replies.gif image   speedometer wild deflections; sometime pump gas
1999 Gmc Savana, rwd, 5.7 (I think) v8 ...

with_replies.gif image  locked wrench.gif Car stalling problem
My 2013 hyundai started losing power whe...

hot_with_replies.gif image   2018 Kia soul. Knocking while accelerating.
Hello, my 2018 Kia soul started making t...

with_replies.gif image  locked   2005 Buick Lesabre surging
My 2005 Buick Lesabre runs good & th...

with_replies.gif image wrench.gif Misfire on coil E
I am new to this forum. I haven't figure...

hot_with_replies.gif image   Having trouble at freeway speeds
It's a 2002 Nissan Sentra 1.8L Automatic...

hot_with_replies.gif image  locked   Annoying shaking during deceleration
Hi fellow enthousiasts! The car is a 20...

with_replies.gif image   Shop says they want to bleed my brakes for a clutch job?
I took my Toyota pickup in for a clutch ...

no_replies.gif image   p119f22 ‘Deterioration of the engine oil’ - 2017 Peugeot Boxer Euro 6 2.0 Blue HDi
Hey guys I’m looking for some advice. ...




starter diying?

Search for (search options)
 



Guest
Anonymous Poster

Oct 8, 2008, 10:51 PM

Post #1 of 4 (1165 views)
starter diying? Sign In
ok when i start my car in the moring i hear a click noise the engine wont start i buy new batts and still does it some times its a stick shif i do push the cluth all the way down when i try to start it it wont then i try again and starts after the engine has been run it dont do it any more only happens to me in the moring..

what cause that? do i need a new starter soon?

thanks


dmac0923
Enthusiast

Oct 9, 2008, 5:37 AM

Post #2 of 4 (1161 views)
Re: starter diying? Sign In
i would look at your neutral safety switch on your clutch. also check the battery terminals are tight and clean on both the battery and other connections. New battery or not damaged or corroded batter terminals must be replaced
__________________________________________________
2015 Jeep Grand Cherokee
2002 Ford Ranger
2004 Toyota Corolla
1969 Ford Mustang Mach 1


HYdrogen_on_Demand
User

Oct 9, 2008, 1:25 PM

Post #3 of 4 (1153 views)
Re: starter diying? Sign In
After a car has been running it is warmed up, the metal parts swell from the heat, and all condensations are evaporated off. Basically what you have is a poor connection somewhere in the system. Take them apart and clean them up with a wire brush and reassemble them tightly. Don't over tighten or you'll break something.

Good luck !!


Guest
Anonymous Poster

Oct 9, 2008, 7:01 PM

Post #4 of 4 (1149 views)
Re: starter diying? Sign In
In Reply To
After a car has been running it is warmed up, the metal parts swell from the heat, and all condensations are evaporated off. Basically what you have is a poor connection somewhere in the system. Take them apart and clean them up with a wire brush and reassemble them tightly. Don't over tighten or you'll break something.

Good luck !!
thanks everyoneSmile

ill give that a look





 
 
 






Search for (options) Privacy Sitemap