|
|
mason43
New User
Mar 24, 2010, 4:56 AM
Post #1 of 9
(1559 views)
|
 88 ford ranger 6cyl, fuel inj 4x4 , gets warmed up and about twice a week it just dies and wont fire back until it cools, sometimes it will cut out going along and giving it gas, cuts out for a few sec. then picks back up. i replaced the ignition module at the distributor but still have the same prob, any ideas? Thanks
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 24, 2010, 5:15 AM
Post #2 of 9
(1553 views)
|
|
Re: runs and dies
|
Sign In
|
|
Is this a long time history of using just twice a week or in storage for some reason? At the age it's open book. Try to isolate whether it's lack of fuel or spark while it's down to narrow it down,
T
|
|
| |
|
|
mason43
New User
Mar 24, 2010, 11:56 AM
Post #3 of 9
(1548 views)
|
|
Re: runs and dies
|
Sign In
|
|
Thanks for the tip, but what i mean is the truck only does this twice a week . i drive the truck every day.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 24, 2010, 2:48 PM
Post #4 of 9
(1544 views)
|
|
Re: runs and dies
|
Sign In
|
|
OK: I suggest having with you some starting fluid to spray in throttle body and a spark tester at a plug when it definitely is acting up. If starting fluid makes it fire up if only a few seconds it's a fuel issue and if no spark seen we chase that down.
Of course checking spark by cranking engine will require a helper or jump the solenoid with key in "run" position to make it crank and look for spark,
T
|
|
| |
|
|
mason43
New User
Mar 24, 2010, 3:59 PM
Post #5 of 9
(1539 views)
|
|
Re: runs and dies
|
Sign In
|
|
Thanks , I will try that, may take a day or two until it happens again. I'll let you know one way or another what it does. Thanks Again !!!!!!!
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Mar 24, 2010, 7:04 PM
Post #6 of 9
(1534 views)
|
|
Re: runs and dies
|
Sign In
|
|
Definitely need to find out what is missing as Tom suggested....
If you jump the starter solenoid make sure the truck is in park or if this is a manual tranny, definitely in neutral with the prk brk on. This bypasses everything and the truck could lurch when jumped............
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 25, 2010, 12:05 AM
Post #7 of 9
(1531 views)
|
|
Re: runs and dies
|
Sign In
|
|
Thanks Sidom! I messed up with that suggestion without adequate warnings of a safety issue. Jeez - even real shops have had vehicles take off on them testing stuff out. Vehicle MUST be securely in park or neutral if std shift, parking brake working and on hard and if in doubt on anything about it DON'T!
T
|
|
| |
|
|
mason43
New User
Mar 25, 2010, 3:54 AM
Post #8 of 9
(1523 views)
|
|
Re: runs and dies
|
Sign In
|
|
Thanks guys, the safety tip was great. i will make sure all is clear. let you know how it works out.
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Mar 25, 2010, 4:59 PM
Post #9 of 9
(1519 views)
|
|
Re: runs and dies
|
Sign In
|
|
Naw, you didn't mess up Tom, that was a good suggestion and I'm sure Mason43 and the 90% of the other readers who will read this, are probably already aware of this.
That was just for the other 10% who will read this thread, I figured we better put in on of those basic type warnings, like what was being debated in that other thread.
I'm just trying to figure out what type of a slash circle or stick man warning would work for this..... Maybe a little stick man running from his truck with a screwdriver in his hand? 
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
2006 Toyoto Camry XLE Driver Side Electric Window Trouble
Tierod end change caused some kind of leak
Grounding Cable, 2017 Jeep Renegade Trailhawk
equipment
Howdy
