|
|
parking brake on equinox 2005
|
|
|
| |
|
|
mollyelm
New User
Apr 20, 2008, 8:17 PM
Post #1 of 4
(8898 views)
|
|
parking brake on equinox 2005
|
Sign In
|
|
how do you adjust parking brake on equinox 2005
(This post was edited by carjunky on Nov 10, 2014, 1:39 AM)
|
|
| |
|
|
way2old
Veteran
/ Moderator
Apr 21, 2008, 5:14 AM
Post #2 of 4
(8890 views)
|
|
Re: parking brake on equinox 2005 how do you adjust
|
Sign In
|
|
Here are the directions from Alldatapro.
Park Brake Adjustment
- Caution: Refer to Brake Dust Caution in Service Precautions. Apply and fully release the park brake several times. Verify that the park brake lever releases completely.
- Turn ON the ignition. Verify the red BRAKE warning lamp is not illuminated.
- If the red BRAKE warning lamp is illuminated, verify the following conditions:
- The park brake lever is in the fully released position and against the stop.
- There is no slack in the park brake cable.
- Turn OFF the ignition.
- Disable the supplemental inflatable restraint (SIR) system. Refer to Restraint Systems.
- Remove the front floor console.
- With the park brake lever in the released position, using ONLY hand tools, loosen the adjusting nut completely to the end of the front cable threaded rod.
- Raise and support the vehicle.
- Remove the rear tire and wheel assemblies.
- Adjust the rear drum brakes.
- Ensure there is no brake shoe drag after adjustment by rotating the brake drums. If drag exists, re-center the brake shoes and perform the brake shoe adjustment again.
- Install 2 wheel nuts to the wheel studs and firmly hand tighten in order to retain the brake drums.
- Lower the vehicle to permit access to the park brake lever.
- Raise the park brake lever 1 detent position.
- Notice: Refer to Fastener Notice in Service Precautions. Using ONLY hand tools, tighten the park brake cable adjusting nut (1) until light to moderate drag is exhibited while rotating the rear brake drums.
- Attempt to rotate the rear brake drums. There should be no rotation forward or rearward.
- Fully release the park brake lever.
- Verify the park brake is released by rotating the rear brake drums. The drums should rotate freely and exhibit no brake shoe drag.
- If the drums do not rotate freely, repeat the park brake cable adjustment procedure.
- Raise the park brake lever 3 detent positions and attempt to rotate the rear brake drums:
- One of the brake drums should not rotate forward or rearward.
- The other brake drum should not rotate forward or rearward, or should require substantial effort to rotate.
- Raise the vehicle.
- Remove the wheel nuts retaining the brake drums.
- Install the rear tire and wheel assemblies.
- Lower the vehicle.
- Install the front floor console.
- Release the park brake lever.
- Enable the SIR system.
Being way2old is why I need help from younger minds
(This post was edited by carjunky on Nov 10, 2014, 1:41 AM)
|
|
| |
|
|
Guest
Anonymous Poster
Apr 21, 2008, 10:54 PM
Post #3 of 4
(8873 views)
|
|
Re: parking brake on equinox 2005 how do you adjust
|
Sign In
|
|
Your rear brks are out of adjustment. check the linings, if worn replace them. If they are still in specs, adjust the shoes & you'll be good
|
|
| |
|
|
Guest
Anonymous Poster
tolinrosco@earthlink.net
Apr 24, 2008, 8:07 AM
Post #4 of 4
(8864 views)
|
|
Re: parking brake on equinox 2005 how do you adjust
|
Sign In
|
|
thanks
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
mdma pills for sale : WhatsApp +33758633852
Drive Shaft Repair
2006 Toyoto Camry XLE Driver Side Electric Window Trouble
Grounding Cable, 2017 Jeep Renegade Trailhawk
equipment
