Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN






idle quality keeps changing?!


Search for (search options)
 



bottles0
Novice

Oct 6, 2008, 10:33 AM

Post #1 of 2 (1540 views)
idle quality keeps changing?! Sign In

Unsure OKay. Sorry I haven't responded in a while. FORD has been working me to death making Mazdas at Flatrock. Anyways, on my 2L DOHC VIN code 3 2003 Ford Focus. I drive 60 -70 mph to work and back, usually 60. Now that it's turning colder, it seems to suck gas even more. I'm getting 30-35 mpg right now (72 miles at 60-65 mph on the highway). I have seen this car do much better than this. I have had it looked at by a few shops, and they can't find a vacuum leak. I changed the ignition coil, wires, and plugs, plus the mass air flow sensor, and I got my acceleration back. But it still has a rough idle. It has had this since 30k, and it now has 125k on it. The idle is rougher in the morning, when I get off of work. When I go, in the afternoon, it's not so bad. The rough idle comes and goes, no matter what time of day, also. In other words, it is rough at startup, and then rough when it feels like it. I'm at a loss as to why. I have changed everything I can think of in the last two years. No codes. I'm going through $35 in gas every two days. Either my gas gauge is lying, or it sucks more gas after an eight of a tank on the gas gauge. And it seems to take a while to idle down after parking in my driveway or at work. Any ideas, please? Thank you.


Double J
Veteran / Moderator
Double J profile image

Oct 6, 2008, 11:21 AM

Post #2 of 2 (1535 views)
Re: idle quality keeps changing?! Sign In

Found this Technical Service Bulletin (TSB) that may apply to your concern.

Article No.
03-19-11

09/29/03 ^ DRIVEABILITY - VARIOUS DRIVEABILITY
CONDITIONS - HARD STARTING START - BATTERY
LAMP FLICKER
^ ELECTRICAL - VARIOUS DRIVEABILITY
CONDITIONS - HARD STARTING START - BATTERY
LAMP FLICKER
FORD:
2002-2003 FOCUS

ISSUE
Some 2002-2003 SVT Focus vehicles may exhibit any of the following Conditions: ^ High Idle Speed On Cold Start
^ Engine Flare On Gear Change
^ Surge Under Light Load Steady State Operation (2000-3500 RPM, All Gears) When Warm
^ Surge Under Light Load Steady State Operation And Accelerations (2000-3500 RPM, All Gears) When Cold
^ Rough Idle
^ Low RPM/RPM Dips
^ Battery Lamp Flicker
^ Hard To Start/No Start
^ Slow Return To Idle
^ Poor Performance/Acceleration
^ Lacks Power On Initial Pull Away

ACTION
A revised PCM calibration has been developed to improve these conditions. If the vehicle exhibits any of these conditions, refer to the following Service Procedure.
You'll need to take it to Ford or a qualified shop with the capabilities to perform the revised calibration.
Hope this helps
Keep us posted

Jim






 
 
 






Search for (options) Privacy Sitemap