Ignition Problem - Random - Engine Troubleshooting


	Auto Repair Home	SEARCH POSTS	WHO'S ONLINE	LOG IN

Automotive Repair

Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:
  Login
  Sign up here!

Latest Forum Post

Strut spring orientation and strut mount tension nut

2017 Nissan rogue awd 2.5 L Put in Monro...

Transmission stuck in part, I have tried everything

So I'm working on my elderly fathers 201...

2017 dodge journey LED headlights on/off randomly

Year of vehicle 2017 Make of vehicle dod...

Kia Soul starter replacement issues!

Okay so my car is a 2010 Kia soul 2.0 en...

Please Help - Knock sound & engine fail

Hi all, Hoping to get some insight and ...

multiple warning lights

2013 GMC Terrain 130,000 miles 4 cylinde...

03 alero no low speed blower

Good day everyone, I have a 2003 Olds a...

04 Chevy 2500hd tail light issues

Help!!! I have changed my combo switch...

1999 Grand Caravan Sport not starting.

Hi. I'm new here. I hope someone can hel...

Brake Seals Bulging

2021 Toyota Corolla LE 1.8l 65,000 mile...

Ignition Problem - Random

Sign up here!

Search for (search options)

Auto Repair Home>> Automotive Repair>> Engine Troubleshooting

stevef7896
New User

Oct 16, 2008, 1:32 PM

Post #1 of 3 (1481 views)

Ignition Problem - Random	Sign In

1992 Buick Century Special
2.5L
130,000 miles

My problem is random. 75% of the time it starts with no issue, runs fine, starts again after making stops. After several hours of sitting, the car will sometimes not start. It turns over, has normal tempo, I hear the fuel injector run, but will not start. I have replaced all spark plugs and wires and checked the resistance of both coils which were fine. I have engine codes 13 and 32.. oxy sensor (which I replaced) and a generic EGR system error.

At this point I am looking for advice, as I'm still rather new to this. I was thinking I would take my ignition control module to autozone to have it tested. Is this a likely cause, or am I going the wrong route?

Thanks in advance for helping to ease this drawn-out headache.

-stevef

Rlmtex
Novice

Oct 16, 2008, 2:55 PM

Post #2 of 3 (1476 views)

Re: Ignition Problem - Random	Sign In

It sounds like you might have a sticky EGR valve

Remove the EGR valve assembly and clean it out with carb cleaner. Make sure you clean out all the passages. Make sure you use a new gasket when you put the EGR valve back on.

That would be where I'd start.

stevef7896
New User

Oct 16, 2008, 5:06 PM

Post #3 of 3 (1468 views)

Re: Ignition Problem - Random	Sign In

I've had mixed answers on whether the EGR valve could be causing the starting problem, so I did try to clean it out and used WD-40, but if you think that could be the whole problem, I'll get some cleaner and give that shot. Thanks.

Search for (options) Privacy Sitemap