|
|
Engine missing under load
|
|
|
| |
|
|
fdakin
Novice
Aug 23, 2010, 1:27 PM
Post #1 of 9
(2330 views)
|
|
Engine missing under load
|
Sign In
|
|
1998 buick skylark 3.1..Engine feels like a dead miss. Not a Slite miss.Only does it when the A/C is on and under a load. I started out with basic tune up. Plugs,wires, And after I replaced the plugs again thinking I might have broken one. checked all over for vacume leaks. Found none. I put on a modual and Coil packs off of an other car and they omh. out the same.Today I took off the fuel rail and chaged the two injector that red the lowest reading. I cant figure this thing out.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 23, 2010, 1:38 PM
Post #2 of 9
(2322 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
You must have a check engine light on. What codes is it storing?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
fdakin
Novice
Aug 23, 2010, 1:41 PM
Post #3 of 9
(2318 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
It is throwing a MAP sencor code And I did check the voltage. With the ingine running the voltage was 1.9
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 23, 2010, 1:43 PM
Post #4 of 9
(2314 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
What was the exact code number. Did you try apply vacuum to it to see what range it has?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
fdakin
Novice
Aug 23, 2010, 1:49 PM
Post #5 of 9
(2311 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
No I didnt I dont have a vacume gauge But it does have good vac. Or at least it feels good. Can I test it with engine vac.?
|
|
| |
|
|
fdakin
Novice
Aug 23, 2010, 2:25 PM
Post #6 of 9
(2293 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
any more ideas?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 23, 2010, 2:31 PM
Post #7 of 9
(2288 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
I'm not out of ideas, Your out of tools.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
fdakin
Novice
Aug 23, 2010, 2:57 PM
Post #8 of 9
(2284 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
Got a pump...what am I looking for?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 23, 2010, 3:01 PM
Post #9 of 9
(2280 views)
|
|
Re: Engine missing under load
|
Sign In
|
|
With the key on, a digital voltmeter attached to the signal return wire and the MAP sensor plugged in, slowly apply vacuum to it. You should see a slow steady climb to or decrease from about .5v on up to about 4.5v with no glitches in between.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Drive Shaft Repair
2006 Toyoto Camry XLE Driver Side Electric Window Trouble
Grounding Cable, 2017 Jeep Renegade Trailhawk
equipment
Howdy
