|
|
|
2008 Ford Escape Engine Noise
|
|
|
| |
|
|
EscapeEsc
Novice
Jun 3, 2011, 3:18 PM
Post #1 of 10
(20310 views)
|
2008 Ford Escape Engine Noise
|
|
|
2008 Ford Escape
3.0L V6
85,000 miles
I am having problems when I start my 2008 Ford Escape and the engine is cold. I get a non metallic knock, the knock continues until the engine is warm. My oil consumption has also increased. From what I have read these are the symptoms of a bad PCV valve. I replaced the PCV valve, the first cold start I had no engine noise. I thought I had successfully fixed the problem with the PCV valve replacement. Now the noise has returned. So I had one good start after the PCV valve was replaced, every other start I have had the metallic noise. Does anyone have any ideas what the problem could be?
|
|
| |
|
|
zmame
Veteran
/ Moderator
Jun 3, 2011, 3:56 PM
Post #2 of 10
(20301 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
It's still under powertrain warranty take it in and get it fixed.
|
|
| |
|
|
EscapeEsc
Novice
Jun 3, 2011, 5:48 PM
Post #3 of 10
(20293 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
The powertrain warranty is expired.
|
|
| |
|
|
zmame
Veteran
/ Moderator
Jun 3, 2011, 7:15 PM
Post #4 of 10
(20285 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
Sorry my bad thinking KM'S .. Haven't had much problems with oil comsumption we have had rear main seals go on them. This is caused by PCV freezing in the winter time and the crank case having no ventilation(build pressure).
We have had problems with lifters in a few of the 3.0L engines. And also VCT solenoids, a faulty VCT solenoid would trigger a engine light though.
How much oil is it using? .. also make sure it's not leaking it(filter leaking, drain plug, seals and etc).
There is also this TSB for noise
FORD: 2008 Escape, Mariner
ISSUE:
Some 2008 Escape and Mariner vehicles equipped with a 3.0L engine, may exhibit a grinding or rattling noise with the engine running, more noticeable at idle. ACTION:
Follow the Service Procedure steps to correct the condition. SERVICE PROCEDURE
- Check the vehicle build date:
- If the vehicle was built from 4/27/2007-4/30/2007, go to Step 2.
- If not, follow normal workshop manual diagnostics. Refer to WSM, Section 100-04.
- Remove the starter, Refer to WSM, Section 303-06.
- Inspect the starter drive for loose washers and/or the snap ring not seated in the shaft groove. Replace as necessary.
- Install the starter, Refer to WSM, Section 303-06.
PART NUMBER PART NAME 5L8Z-11002-AA (SA-917) Starter
WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part. OPERATION DESCRIPTION TIME 071409A 2008 Escape/Mariner 3.0L Engine: Replace Starter, Includes Time To Inspect Build Date And Starter Drive (Do Not Use With 11002A) 0.6 Hr.
Copyright © 2007 Ford Motor Company
(This post was edited by zmame on Jun 3, 2011, 7:16 PM)
|
|
| |
|
|
EscapeEsc
Novice
Jun 5, 2011, 1:20 PM
Post #5 of 10
(20263 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
Thanks for the reply!
It uses about a quart about every 1000 - 1500 miles. I have checked the oil filter, drain plug, and did a visual inspection of the engine (areas that I could see) from the top/underside and there are no apparent leaks.
This noice is not a grinding or rattling, it sounds non metallic. It seems like the noise is coming mostly from the bank of cylinders closest to the radiator. To further narrow it down it is on the right side of that bank of cyliners (standing at the front of the vehicle looking towards the rear of the vehicle). I can't tell if it is coming from that cylinder or something else in that area.
I would think maybe it could be an injector, ignition coil, or spark plug but it goes away when the engine gets warm. I would think if it was one of these the sound would be heard regardless of hot or cold?
|
|
| |
|
|
zmame
Veteran
/ Moderator
Jun 5, 2011, 2:49 PM
Post #6 of 10
(20258 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
may be a lifter i would know if i could hear it, but im not actually there. does the sound rate change with RPM?(faster)
I would have it put on a hoist to get a good visual make %100 sure it's not leaking. Pull the inspection plate off bellhousing and inspect for signs of engine oil. Take off rubber snorkal for air box and open air box to look for any signs of oil. If engine light is on get it scanned and post the codes here.
|
|
| |
|
|
EscapeEsc
Novice
Jun 16, 2011, 6:59 PM
Post #7 of 10
(20208 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
I took it to a dealership and they determined it to be leaking exhaust header gasket. It kind of makes sense, I smelled slight exhaust in the engine compartment when I was trying to troubleshoot. When the engine/exhaust header gets warm it seals itself. I did not get the dealer to repair yet they wanted $1000 to replace a $10 gasket. Does anyone have an idea of how involved this job is? Any info would be greatly appreciated!
|
|
| |
|
|
zmame
Veteran
/ Moderator
Jun 16, 2011, 7:14 PM
Post #8 of 10
(20202 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
depends if it's front or rear exhaust manifold(s) or converter gasket.. both exhaust manifolds are not nice to remove since they are burried you LH side takes little longer then the RH. Ford SLTS are 3.6 for left 3.2 for right.
Remember these are warranty SLTS (service labour times) and retail labour times will be more. Warranty usally pays about 1/2~3/4 of the time it acutally takes.
|
|
| |
|
|
fixauto4b
Novice
Dec 4, 2013, 9:49 AM
Post #9 of 10
(13868 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
hi, just joined and hoping it is ok to post here as i have a similar problem.
zmame indicated he might be able to identify issue if hearing engine noise.
i have posted http://www.youtube.com/watch?v=xBFbNPbWVF8 an issue with my escape 2008... loud engine tick/nock.
looking for any guidance on whether i can do anything. i am planning to tow to a service station for diagnostics.
from what i gather from searching internet for FordEscapes... if major issues with valves/pistons/bearings,
it may be best to just replace engine(remanuf) vs repairing.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Dec 4, 2013, 11:44 AM
Post #10 of 10
(13857 views)
|
|
Re: 2008 Ford Escape Engine Noise
|
|
|
Please read the FORUM RULES before post. This question belongs to someone else and it 2 1/2 years old.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Strut spring orientation and strut mount tension nut
Please Help - Knock sound & engine fail
Brake Seals Bulging
