|
|
|
1992 jimmy random stalling
|
|
|
| |
|
|
timitaoe
User
Aug 5, 2013, 5:44 PM
Post #1 of 9
(1327 views)
|
|
1992 jimmy random stalling
|
Sign In
|
|
this is the same 1992 jimmy you helped me with befor.
it runs good no flaws or skipping or nothing when it runs. but it stalls at random times. its reading code 15 & 43 im using an actron cp9001 the site says
15 is low coolant temperature
43 is electronic spark timing malfuntion.
i just changed the fuel spider, while i had it apart i did cap and rotor, and wires the plugs were new when a altinator locked up it destroyed a plug so i just changed them all.
when it stalls sometimes it starts right back up other times you have to wait about 15-30 mins.
thanks
-tim
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 5, 2013, 5:48 PM
Post #2 of 9
(1323 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
The code 43 is a hint there may be a problem with the Ignition Control Module.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Aug 5, 2013, 5:54 PM
Post #3 of 9
(1316 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
You sure that is code 43...cause 43 is for the knock sensor circuit.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
timitaoe
User
Aug 5, 2013, 5:55 PM
Post #4 of 9
(1314 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
ok will see what that does... there isnt a way to test that is there.. thats just a replace and pray right?
i also forgot to mention the map sensor had a hole busted in it when i took the vortec cover off and i replaced it with a brand new 1 i had in the shed. but i think i got that for a 5.7 cant remember thogh. would that be different?
|
|
| |
|
|
timitaoe
User
Aug 5, 2013, 6:01 PM
Post #5 of 9
(1311 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
link deleted ............... not allowed
is the website i used to look the codes up and its the site on the back my scanner and it says somehing bout spark and timing
but yes its blinked 15 & 43 and the usual 12 to say the computer thing works
(This post was edited by Hammer Time on Aug 5, 2013, 6:03 PM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 5, 2013, 6:05 PM
Post #6 of 9
(1308 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
From Alldata
CODE 43 - Electronic Spark Control (ESC)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
timitaoe
User
Aug 5, 2013, 6:13 PM
Post #7 of 9
(1304 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
esc is the box that plugs into the distributor right? is that the only thing the code 43 can mean?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Aug 5, 2013, 6:15 PM
Post #8 of 9
(1300 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
Never heard of a knock sensor fault causing the engine to stall out.
Circuit Description:
The Code 43 circuit consists of two knock sensors with one wire that is spliced together and goes directly to the ECM. There are two Code 43 cheeks performed by the ECM. One check consists on monitoring CKT 496 for a voltage that is above 0.63 volts and below 4.38 volts.
If voltage is either too high or too low, for 2 seconds, Code 43 will set. Once engine temperature reaches 20°C increase from start up or 85°C, MAP reading above 83 kPa and engine speed below 3800 rpm, the ECM will perform a self check by advancing the timing incrementally up to additional 23° advance while anticipating a knock signal. If no knock signal is received during the test, Code 43 will set.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Aug 5, 2013, 6:18 PM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 5, 2013, 6:19 PM
Post #9 of 9
(1296 views)
|
|
Re: 1992 jimmy random stalling
|
Sign In
|
|
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Strut spring orientation and strut mount tension nut
Please Help - Knock sound & engine fail
Brake Seals Bulging
