Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









SECURTY LIGHT BLINKS


Search for (search options)
 



big ed
New User

Jul 30, 2010, 11:43 AM

Post #1 of 5 (1471 views)
SECURTY LIGHT BLINKS Sign In

1995 BUICK REGAL GRAND SPORT 3.8 ENGINE 130K CAR WOULD NOT START AND NO CRANK, TRACED PROBLEM TO THEFT DETERANT MODULE, REPLACED MODULE AND CAR STARTS FINE AND RUNS FINE BUT SECURTY LIGHT FLASHES ALL THE TIME. DOES IT HAVE TO BE REPROGAMED SOMEHOW ?


Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Aug 1, 2010, 7:33 AM

Post #2 of 5 (1453 views)
Re: SECURTY LIGHT BLINKS Sign In

Guess and not much help right away: I think all these had the chip on the key and the new module you replaced isn't oriented to the key. Actually I'm surprised it runs now at all.

If so there is a way that I don't have software for to orient the key to the security system,

T



Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Aug 1, 2010, 7:52 AM

Post #3 of 5 (1448 views)
Re: SECURTY LIGHT BLINKS Sign In

PROGRAMMING A NEW DECODER MODULE

Key Code And Resistance Chart

New decoder modules are unprogrammed. Before the system will function properly after a new module has been installed, it must be programmed to the code that matches the customer's keys. Programming a new module is very simple:
  1. Install the new, unprogrammed decoder module.
  2. Insert one of the customer's keys in the ignition lock cylinder and turn it to the "ON" position. It's a good idea to start the engine at this time to verify system operation.
  3. Observe the "SECURITY" Indicator Lamp:
    • The indicator lamp should light for about 5 seconds and then go out. If the wiring or contacts to the Key Resistance Pellet or the key is defective or intermittent and a new module is installed, the Engine will start but the "SECURITY" Indicator will flash at a rate of one flash per second until the Ignition Switch is turned off. This indicates that the module did not program and that the system components, wiring and contacts should be checked for a fault.
IMPORTANT: Before connecting the Interrogator to the ignition lock cylinder circuit, always verify vehicle key code and set the code into the Interrogator using "key code" knob. This will prevent programming an unprogrammed decoder module with an undesired key code.



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Aug 1, 2010, 7:57 AM

Post #4 of 5 (1441 views)
Re: SECURTY LIGHT BLINKS Sign In

I just knew you'd have the info on that!

T



big ed
New User

Aug 2, 2010, 3:29 AM

Post #5 of 5 (1430 views)
Re: SECURTY LIGHT BLINKS Sign In

THANKS FOR THE INFO I WILL CHECK THE KEY CODE VALUE.






 
 
 






Search for (options) Privacy Sitemap