|
|
96 town and country limp mode and p1768
|
|
|
| |
|
jssndjy
New User
Jun 12, 2009, 6:43 AM
Post #1 of 6
(3674 views)
|
96 town and country limp mode and p1768
|
Sign In
|
|
1996 chrysler town and country lxi 3.8 v6 185000 miles Hello, I have a code p1768 and vehicle is in limp mode. Also the wipers, horn, tail lights, ac/heater console and blower are not working. can it be the camshaft or crankshaft sensor. if not can you give me a suggestion. thank you!!!
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 20, 2009, 9:44 PM
Post #2 of 6
(3659 views)
|
Re: 96 town and country limp mode and p1768
|
Sign In
|
|
Try disconnecting neg bat cable for 1/2 hour - turn headlights on while disconnected then retry + report back, T
|
|
| |
|
jssndjy
New User
Jun 21, 2009, 1:11 AM
Post #3 of 6
(3650 views)
|
Re: 96 town and country limp mode and p1768
|
Sign In
|
|
Try disconnecting neg bat cable for 1/2 hour - turn headlights on while disconnected then retry + report back, T Still same problem. can it be the harness I am not getting voltage to the wiper relay.
|
|
| |
|
jssndjy
New User
Jun 21, 2009, 1:46 AM
Post #4 of 6
(3648 views)
|
Re: 96 town and country limp mode and p1768
|
Sign In
|
|
i tried changing harness and still nothing
|
|
| |
|
Sidom
Veteran
/ Moderator
Jun 21, 2009, 6:20 AM
Post #5 of 6
(3642 views)
|
Re: 96 town and country limp mode and p1768
|
Sign In
|
|
Well...definately sounds like you got an electrical problem there. Just that fact that you can pull codes & aren't getting a "NO BUSS" on the odometer is good. Depending on what the problem is might be a little tough to do over the internet. You could cover the basics, check the batt cables, the power feed from pos cable going to the distribution box, make sure the grounds are good & clean. Chryslers have had their problems with igniton switches & clusters. You could do a "wiggle" test on some of the connectors. gently wiggle them & see if you get some kind of intermitten contact.... I would definately look at the ign sw connecter.... I know it's not much but hope it helps.....
|
|
| |
|
way2old
Veteran
/ Moderator
Jun 21, 2009, 6:44 AM
Post #6 of 6
(3635 views)
|
Re: 96 town and country limp mode and p1768
|
Sign In
|
|
I searched my information and can not find a P1768 code for the model year you have. Are you sure of the code number? The codes in that area jump as follows. P1765 -Trans. 12 volt supply relay control circuit P1899 -P/N Switch Failure Being way2old is why I need help from younger minds
|
|
| |
|