|
|
gmfan2014
New User
Dec 10, 2014, 9:19 AM
Post #1 of 8
(1967 views)
|
Hello,
I have a 2002 Oldsmobile Alero with a 2.2L eng. It has about 80K km. I am experiencing a very hard brake pedal. I have replaced the brake booster, master cylinder, ABS module and booster check valve. All calipers have been checked and are moving freely. All brake lines from front to back are new. Any suggestion on what may be causing this?
Thanks,
Sam
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Dec 10, 2014, 9:22 AM
Post #2 of 8
(1965 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
With the engine off pump the brake a couple times. Now plant your foot on it firmly and start the engine.
Did the pedal drop considerably when the engine started?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
gmfan2014
New User
Dec 10, 2014, 9:25 AM
Post #3 of 8
(1959 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
Hello,
No the brake pedal does not drop when the pumped with the engine off. Almost same stiffness.
Thanks,
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Dec 10, 2014, 9:44 AM
Post #4 of 8
(1950 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
That's not what I said. I said pump it a couple times to discharge it and then press on it firmly and start the engine while pressing.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Dec 10, 2014, 10:45 AM
Post #5 of 8
(1943 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
Right as Hammer suggested. If you don't feel it exhausting assist when engine is off it didn't have any to begin with so look for a fault in getting and keeping vacuum where it belongs even in the new items mentioned that should do that if new could be a silly rubber grommet that doesn't seal?
T
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Dec 10, 2014, 10:52 AM
Post #6 of 8
(1938 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
Can we let him run the test I asked for before taking a left turn?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
gmfan2014
New User
Dec 10, 2014, 1:29 PM
Post #7 of 8
(1923 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
hello,
I performed the test as you requested. When the car was started, the pedal went down all the way and then after pumping it a few more time while engine running, it became hard again as it was before the test was performed.
Thanks,
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Dec 10, 2014, 5:00 PM
Post #8 of 8
(1911 views)
|
|
Re: Hard Brake Pedal
|
Sign In
|
|
OK, that test proves that the booster is working properly and your problem is elsewhere. It sounds like you may have lost one side of the dual system. I would get all four wheels in the air and have someone hold the brake until it hits that hard spot and see if someone else can turn any of the wheels by hand.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
