|
|
|
2016 Camry "check brake system"
|
|
|
| |
|
|
Superbee
New User
Jun 23, 2022, 10:53 AM
Post #1 of 12
(1300 views)
|
2016 Camry "check brake system"
|
|
|
I replaced the rear brake pads, rotors and calipers and as I was bleeding the rear brake lines I got check brake system message. I topped off the brake fluid after bleeding each rear brake line but am still getting the message.
I only bled the rear brake lines. The brakes are not spongy, no leaks found. Any thoughts on what the problem is?
Any help would be greatly appreciated. Thank you.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 11:53 AM
Post #2 of 12
(1297 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
First make sure the fluid level float is working and it has sufficient fluid. If that is not the problem then it has likely set a code for uneven brake pressure and you may need a scan tool capable of reading the brake system to read and clear it. I'm assuming you have a good brake pedal now. If not you have other issues.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Superbee
New User
Jun 23, 2022, 1:16 PM
Post #3 of 12
(1284 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
I tried checking the float sensor with an ohmmeter, reads open but I can't see the connector pins to tell if I'm making good contact. I could try buying another mating plug (if cheap enough) so I can be sure I am making good contact.
I presume the proper way to check the sensor is to drain the fluid enough to see if it goes to a shorted condition?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 1:20 PM
Post #4 of 12
(1282 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
I usually just tap the side of the reservoir with a screwdriver handle to make sure the float isn't stuck at the bottom.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Superbee
New User
Jun 23, 2022, 4:22 PM
Post #5 of 12
(1255 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
Didn't see a float.
I used an OBD reader from the auto store - no faults reported.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 5:18 PM
Post #6 of 12
(1249 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
That isn't going to help you. You need something that reads ABS. It has to be professional level.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 6:06 PM
Post #7 of 12
(1241 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
Quote OP ">I only bled the rear brake lines.<
? Seems new but I would just hold that firm pedal and just bleed out a little from a front bleeder. System is possibly off center for the way (IDK) you bled just rear brakes will probably re-center with doing that.
New fluid is good for a system few do it proactively or as periodic - even me on way too many assorted vehicles all could use new fluid hard as you try it too gets old and out of spec from new,
T
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 6:10 PM
Post #8 of 12
(1236 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
That centering stuff went away years ago with ABS and staggered hydraulic systems.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 7:05 PM
Post #9 of 12
(1229 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
I still suggest bleeding fluid OUT only, a little from the fronts. Fluid and or balance of however designed isn't happy there's no mention of a problem until doing this job,
T
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 23, 2022, 7:09 PM
Post #10 of 12
(1227 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
If he got any air into the ABS unit he may need a professional scan tool to bleed it out.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Superbee
New User
Jun 25, 2022, 3:49 PM
Post #11 of 12
(1181 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
As I thought more about it, it just made sense that the float had to be stuck so I tapped on it a bit harder and longer a second time and that did it! No more faults.
Good call. Thank you.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 25, 2022, 3:52 PM
Post #12 of 12
(1178 views)
|
|
Re: 2016 Camry "check brake system"
|
|
|
Yep, happens a lot.
I'll close this now as solved.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
