Latest Forum Post
04 Chevy 2500hd tail light issues
Help!!! I have changed my combo switch...
1999 Grand Caravan Sport not starting.
Hi. I'm new here. I hope someone can hel...
Brake Seals Bulging
2021 Toyota Corolla LE 1.8l 65,000 mile...
Engine blew up after oil change, is mechanic responsible?
Hello, I have a 2007 Hyundai Elantra wit...
Changed pads and now brake pedel goes to the floor
I am not much of a mechanic, and needed ...
Equinox air conditioning issue, help please!
I have a 2020 Chevrolet Equinox that has...
2005 Maxima overheats only when idling but engine temp comes down immediately if I rev up the engine (even though car is stationary)
hello everyone, I own a 2005 Nissan M...
Brake & Turn Signal Out - One side only
2002 Ford Ranger 3.0 V6, 5-speed manual ...
Seeking Advice: Strange Noise in 2017 Nissan Versa Note, Mechanic Stumped
Hey everyone, A few weeks ago, my mom's...
Replacing Tires
My daughter just purchased a 2013 Honda ...
|
|
Sentra only works in reverse and drive
|
|
|
| |
|
kellybig
Novice
Jul 28, 2016, 6:43 PM
Post #1 of 15
(2026 views)
|
Sentra only works in reverse and drive
|
Sign In
|
|
Helping a friend with his car. Says he put another used tranny in because car was throwing codes and bogging down. Codes are po755 solenoid b tranny code: po731 1st gear ratio code: and po505 code idle air control code. I replaced the solenoids on the cheap. No change. He indicates he sent the ecm into have tested and it is all good. Battery has good amps, no missing fuses. Car only works in drive park neutral and reverse. Dies frequently. Will not up shift or downshift. I am am skeptical that 2 used granny's and solenoid sets are bad. It is a 2001 Nissan Sentra gxe automatic with a 1.8 liter engine. Confused on what to try next. I'm thinking the transmission control unit. Any advice is much appreciated.
|
|
| |
|
gsferraro
Veteran
Jul 29, 2016, 5:29 PM
Post #2 of 15
(2006 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Hello, I believe the P0755 on this trans is an eletrical code, that is why the car is in failsafe, if you clear the code does it come right back?
|
|
| |
|
kellybig
Novice
Jul 29, 2016, 5:54 PM
Post #3 of 15
(2002 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Yes. It does.
|
|
| |
|
gsferraro
Veteran
Jul 30, 2016, 9:35 AM
Post #4 of 15
(1992 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Helo, Of course you have to fix that first, that can be solenoid, wire or computer, but make sure you check fuses and connections first, then ohm the solenoid at the computer, this will check the wire and solenoid. Gary
|
|
| |
|
kellybig
Novice
Jul 30, 2016, 8:53 PM
Post #5 of 15
(1985 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Thanks for the replies Gary. I replaced the solenoid so that rules that out. I am going to replace transmission control unit in the am. The ecm is good. If this does not work should I just start ohm testing all wires from the computers to the tranny?
|
|
| |
|
kellybig
Novice
Jul 30, 2016, 8:54 PM
Post #6 of 15
(1983 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Forgot to add, fuses are all good.
|
|
| |
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 31, 2016, 4:38 AM
Post #7 of 15
(1980 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
I didn't read anywhere that Gary said to replace anything. His instructions were to TEST to find the issue. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
kellybig
Novice
Jul 31, 2016, 9:20 AM
Post #8 of 15
(1970 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Because I do not have full time access to the car, replacing the TCU to rule it out is a nominal amount to me.
|
|
| |
|
kellybig
Novice
Jul 31, 2016, 7:23 PM
Post #9 of 15
(1957 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Today had time to pull electrical connections leading from the harness to the tranny; 2 female ends, one had 9 wires/holes to 9 pins the other had seven wires/holes to 6 pins the male end at the top of the transmission is very hard to see; looks like one pin could be broken off; found what looks like a wire coming through on this female end; could this be the culprit?
|
|
| |
|
gsferraro
Veteran
Aug 1, 2016, 7:23 AM
Post #10 of 15
(1943 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Any corrosion on the wires? It could be the problem.
|
|
| |
|
kellybig
Novice
Aug 1, 2016, 10:00 AM
Post #11 of 15
(1937 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
no corrosion ; just a protruding wire and possible broken pin
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Aug 1, 2016, 10:12 AM
Post #12 of 15
(1936 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
? You see this "possible" protruding wire and broken pin but don't seem so sure. Understood some are hard to get a good look but if just connected ohm test that suspect wire for just continuity. Yes a broken wire or lack of connection can screw things up - anywhere but you have a problem and this in front of you so fix it or know it's good now, T
|
|
| |
|
kellybig
Novice
Aug 1, 2016, 3:26 PM
Post #13 of 15
(1928 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
I tried to get a couple of pics but they came out bad. Very difficult to see. When I go back I will try to get some pics and test it. I met this guy on Craigslist. He is 94 years old. You are correct. I am not sure. Ran out of time and had to be to another appointment. I can only get over there every few days.
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Aug 1, 2016, 4:19 PM
Post #14 of 15
(1925 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Try getting an automotive dental type mirror if need be - not for a picture just to verify this is broken or not by sight first, T
|
|
| |
|
kellybig
Novice
Aug 1, 2016, 4:29 PM
Post #15 of 15
(1922 views)
|
Re: Sentra only works in reverse and drive
|
Sign In
|
|
Will do
|
|
| |
|