|
|
egine stahls then starts back up
|
|
|
| |
|
|
nomad_564
User
Jan 7, 2012, 2:20 PM
Post #1 of 7
(1503 views)
|
|
egine stahls then starts back up
|
Sign In
|
|
have a 93 olds 98 3.8 ltr when cold it starts up fine runs till operating temp them engine dies every thing else is still on, and i just noticed excelleration is off can not excel fast even with pedal on the floor it has a slow constant excel
noticed engine service light goes on and off not in a regular interval
have already replaced all vacuum line hoses ( most where dry rotted ) new plugs and wires , new air filter.
tested ingition control and tested fine now im at a loss
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jan 7, 2012, 5:09 PM
Post #2 of 7
(1463 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
Get the codes - even OBDI will have something to say with the CEL on or blinking. By description so far I would chase down exhaust restriction like the converter which may flow better cold,
T
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jan 7, 2012, 7:36 PM
Post #3 of 7
(1451 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
Checking for codes is a good idea.
You can do that by jumpering A to B in the ALDL connector. Turn the ignition on and the ECM will flash the check engine light for codes it is storing.
Another thing you can try is a tap test on the ECM itself. Wasn't uncommon for the circuit boards in the tin can ECMs to crack and cause intermittent stalling and other weird engine running problems. Unbolt the ECM with the connectors attached and start the engine. Let it warm up and then with an open palm lightly smack the back of the ECM opposite the PROM cover. If the engine stalls when you smack it, you probably have a cracked board. Don't smack it too hard or you might crack the board if it wasn't cracked in the first place.
Another thing that could cause intermittent stalling when hot is a failing crankshaft position sensor. The only way your going to figure that out is by watching the crank signal with an oscilloscope to see if it glitches out when the engine stalls.
It would be nice if the engine wouldn't restart after it stalled because that would make it easier to figure out what goes missing, but not everything is flowers and bunny rabbits in the automotive world.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Jan 7, 2012, 7:47 PM)
|
|
| |
|
|
nomad_564
User
Jan 10, 2012, 3:08 PM
Post #4 of 7
(1412 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
ok got the code dtc 22 low throttle position switch was only 1 stored
how hard is it to get to ?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jan 10, 2012, 5:22 PM
Post #5 of 7
(1405 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
You might want to test the sensor and its circuit before condemning it. You can do a voltage sweep test of the sensor itself to see if has any dead spots. If you could get your hands on a scan tool that can view data stream information, you could monitor the TPS voltage also, just to be sure you don't have a wiring or ECM problem.
The TPS is located on the throttle body and has to be adjusted with a DVOM or scan tool if a new one is installed.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
nomad_564
User
Jan 10, 2012, 5:41 PM
Post #6 of 7
(1399 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
i dont have those kind of tools
have much is a shop gonna charge for somethin like that?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jan 10, 2012, 6:03 PM
Post #7 of 7
(1390 views)
|
|
Re: engine stalls then starts back up
|
Sign In
|
|
You would have to call some shops in your area and find out what their diagnostic charge is.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
2011 Dodge Nitro OBD scanner seems to drain battery in 10-20 minutes
Grounding Cable, 2017 Jeep Renegade Trailhawk
equipment
Howdy
