|
|
QualiT23
Novice
Mar 21, 2017, 12:12 PM
Post #1 of 13
(1288 views)
|
|
Alternator Short Help!
|
Sign In
|
|
Hey guys. I did something stupid... I had the alternator off to check a pulley. I started up the truck, and the alternator vibrated back because I didn't retighten it. The terminal on the back of the alternator then touched the engine block, sparked, and everything went dead. Im curious if anyone has advice as to what would have blown? Battery still works fine, I've double checked all the fuses under the dash, and they are fine. Starter works if I arc the terminals together. My truck is a 1980 chevy silverado (K20) with a 350. Any help would be much appreciated. thanks.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Mar 21, 2017, 12:56 PM
Post #2 of 13
(1280 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
Check your fusible links.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Mar 21, 2017, 12:57 PM)
|
|
| |
|
|
QualiT23
Novice
Mar 21, 2017, 1:25 PM
Post #3 of 13
(1269 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
I checked the one with an ohm meter by the starter, and the other one was up on the driver side of the truck. Both are good. Are there more than two on the old square body trucks?
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 21, 2017, 2:04 PM
Post #4 of 13
(1261 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
Interesting and surely a problem. Just maybe the alternator itself is a strong short and hasn't blown a fusible link but rather draws away excessive current inside itself.
Just as a test for unusual try disconnecting the eyelet end and assertively isolate it from grounding. See if all comes back and if so alternator is shorted inside which may only do that when turning or still? Why? A sudden surge to charge beyond it's capability burnt inside,
T
|
|
| |
|
|
kev2
Veteran
Mar 21, 2017, 3:35 PM
Post #5 of 13
(1247 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
alt has 3 wires - the 2 red wires should have 12v - yes no?
fusible link from batt to alt.
|
|
| |
|
|
QualiT23
Novice
Mar 21, 2017, 5:42 PM
Post #6 of 13
(1233 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
Ok, we got it! Luckily, an old timer I ran into at the post office had nothing better to do than mess around with my truck. It turned out to be the positive line from the battery to the alternator. Coincidentally, it was fried and pretty much dust inside when we cut it open. This last jolt must have been all it needed to finish it off. He couldn't believe it blew before the fusible links did. Anyway, I appreciate the quick response from everyone! First time on this site, and certainly won't be my last. Thanks.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 21, 2017, 6:17 PM
Post #7 of 13
(1229 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
That wire IS a fusible link. You cannot simply replace that with regular wire. It have to be repaired with fuse wire.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 21, 2017, 10:24 PM
Post #8 of 13
(1219 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
? I thought you said that wire showed it was good? As HT just said and don't wait, replace that with "fusible link" wire of same rating. It's sold and marked at auto parts outlets + marked again on the wire very small what it is. It's meant to fry just more usually all wrinkled and obvious,
T
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 22, 2017, 2:24 AM
Post #9 of 13
(1213 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
You won't use fuse wire on the entire length of the wire, just the section that is already fuse wire. You should see a separation there to identify where the link stops and regular wire starts.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
QualiT23
Novice
Mar 22, 2017, 5:33 AM
Post #10 of 13
(1197 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
Let me be a bit more clear on how little I know of this. I saw the fusible link and assumed the connecting piece where one wire splits into two was the actual fuse, not the wire itself. I checked the wire on each side of the splitter, it was good, so I assumed the wire was good. I went back to the comment section on a youtube video where I watched that, and they lit let the guy on fire for explaining it wrong. I should have read that first. But hey, I wouldn't have stumbled onto this site if I had!
|
|
| |
|
|
QualiT23
Novice
Mar 22, 2017, 5:34 AM
Post #11 of 13
(1195 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
Hammer time, we did use a fusible wire. We did, however, replace the entire length.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 22, 2017, 5:42 AM
Post #12 of 13
(1191 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
As HT said, just use the length that burned up even unseen and inside it would all be crunchy. It's color coded and rated like fuses are so use only the correct stuff. Do solder it in and shrink wrap over splice.
It's supposed to blow when something goes wrong or horrors worse than you had happen would happen. IDK - sold as you found new stuff in a blister pack or off a roll just make sure of right length and rating to blow otherwise it's just wire looking,
T
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Mar 22, 2017, 7:03 AM
Post #13 of 13
(1182 views)
|
|
Re: Alternator Short Help!
|
Sign In
|
|
You can't do that. The length of the fuse wire varies the amperage rating. You need to use the same length of fuse wire that it came with, usually only a few inches.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
2011 Dodge Nitro OBD scanner seems to drain battery in 10-20 minutes
Grounding Cable, 2017 Jeep Renegade Trailhawk
equipment
Howdy
